Standard Plaque, Inc.

Pricing

Pricing Information 

200 Ton Van Dorn-14 oz. Barrel

 

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

165 Ton Cincinnati- 13 oz. Barrel

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

110 Ton Supermax-10 oz. Barrel

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

150 Ton Shine-7.6 oz. Barrel

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

110 Ton Cincinnati- 12 oz. Barrel

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

80 Ton Newbury- 2.3 oz. Barrel

Mold/machine set-up             $225.00

Mold/shop time                      $110.00/hr.

Runs exceeding 25 hrs.        $85.00/hr.

 

100 Ton Wabash Compression Molding  

Mold/machine set-upN/C

Molding/shop time                  $125.00/hr.

12”x12”x 0.125” - 0.500”

 

1.5” 5hp Single Screw Sterling Extruder

Extruding time                        $85.00/hr.

 

 

Painting, Consulting, Mold Fabrication

Pricing per individual requirements 

 

Moisture Proof Sealed Sample Bags

12”x12”x 0.005” bag   $5.00/bag

 


 

Additional Information

Immediate response time. All services can be initiated within 72 hours of receiving material. Normal laboratory hours are 8am-12 midnight. Extended runs can be conducted around the clock to expedite large orders.

10,000 ft off-site warehousing facilities

Secrecy agreements and non-disclosure agreements available upon request

Supplier, at his/her option, is welcome to be on-site and to participate in all services offered

 

Sample Calculations

 2 cavity mold# 1A-1 5”x 5”x0.100”

Cycle time for optimum test panels- 55 sec

Utilize 165-ton Cincinnati

5 pcs/lb= 100lbs material required 

$225.00 Mold/machine set-up includes:

            -Material handling/mixing

            -Material drying

            -Moisture analysis (prior to molding)

            -Mold set-up

            -Machine purging

4 hr. minimum at $110.00/hr.

Appprox. 2pcs/min x 60 min x 4= 480 pcs.

Total cost= $665.00 (plus shipping)

 

Note: There is a 4 hour minimum Mold/shop time for each job and the total cost to mold 1 plaque to 400 plaques would be the same (in a 2 cavity mold)

MSDS to be in-house for all materials prior to project start-up

 

*Prices subject to change at anytime*